Mytee Products Hitch Mounted Barbed Wire Unroller Bolt On ATV and 2″ Receiver Hitch Compatible for Fencing, 5 Adjustable Height Setting

Description

Hitch Mounted Barbed Wire Unroller of we are here to make fencing operation/installation simpler and smoother, particularly in agricultural and construction sites. Our ATV unroller will enable you to facilitate controlled dispensing of barbed wire compared to manual methods. Attach these wire unrollers to your truck or tractor 2″ receiver or connect them with your ATV using a removable adaptor. Learn more features about this product below:-

• Adjustable Height: The overall length of our barbed wire unroller is 28-1/2″ whereas the width is 24″. It further includes 5 vertical adjustable height settings for precise wire placement. You can set the wire at the perfect height for your project. These five 5/8″ pre-drilled holes are available at a distance of 1-1/2″, which you will secure with locking pins (with clip).
• Black-Powder Coated: We have engineered our wire unroller from steel to add strength and durability. We have constructed it in square tubing to withstand the rigors of outdoor use, especially agricultural and construction. We have further coated our product (except spool) with black powder to make it rust and corrosion-resistant. It will ensure longevity even in outdoor settings.
• Capacity: Now, ensure smooth and efficient operation during the fencing project with our ATV wire unroller can hold up to 1 roll up to 80 rods, which requires a max spool width of 16″. It will further enable you to run a wire maximum of 1,320 feet long.
• Compatibility: Our wire unroller is compatible with 2″ receivers and it seamlessly fits with trucks. You can also connect to a tractor or ATV with a receiver mount plate. You will need an adaptor to attach these wire unrollers in your ATV (bolt to the rear of your ATV). It will enable you to reach areas your truck or tractor cannot access. Utilize these barbed wire unrollers in agriculture for livestock management, pasture fencing, site security.
• Removable Telescopic Spool: Our barbed wire unroller features a removable telescopic spool of 17-1/4″ in length, which can hold up to a spool width of 17-1/4″. To put the barbed wire in the spool, you have to remove one tubular bar (now the two-piece slot will come apart), place the wire inside, and then combine both the pieces together. Now, place the spool on the support legs and secure them with the pin.
• Hassle-Free Installation: You have to assemble these products and secure the assembly with locking pins with clips. Once you have assembled the wire unroller, you can slide the bottom square tubing into the standard 2″ receiver of the truck. Once the tube is inside, lock it with a safety pin.

Note:

1. Install these under professional supervision and competent individuals as the use of equipment involves the potential risk of injuries.
2. You accept and assume full responsibility for injuries and damages (both economic and non-economical) after using said equipment. We (including insurers, employees, officers, directors, associates, and agents) take no responsibility for any damages, demands, claims rights of action, or causes of action in the present or future, whether known or unknown, anticipated or unanticipated.

WE MAKE NO WARRANTY WHATSOEVER CONCERNING THE EQUIPMENT, INCLUDING ANY WARRANTY OF MERCHANTABILITY OR WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE, WHETHER EXPRESS OR IMPLIED BY LAW, COURSE OF DEALING, COURSE OF PERFORMANCE, USAGE OF TRADE OR OTHERWISE. BUYER ASSUMES ALL LIABILITY IN THE USE OF THE EQUIPMENT.